It looks like you're new here. If you want to get involved, click one of these buttons!
Can't see model in pose mode
edited January 17
When entering pose mode, the model (bunny, or the other templates) goes completely invisible; only the nodes can be seen.
Also, I can manipulate said nodes, but cannot retain their position when I exit pose mode.
Is this normal?
Thanks in advance.
Sorry for the delay.
Here's what the issue looks like:
This is a very strange problem. I can't find anything out of the ordinary in the logs. You are using a rather potato graphics chip though, so that might have something to do with it.
All I can recommend is updating your gfx drivers:
Let me know if it helps!
Oh, the pose in edit mode will always be a T-pose, but if you go back to pose mode, the pose you configured should remain from before.
Looks like my hardware is the issue. Guess YL2 is something I'll have to look forward to when I get a more capable setup.
Thanks for all your help.
edited January 27
Did you try updating the driver? The one you were using when reporting this problem is more than 1 year old, so that may very well be the problem.
I did. I got an error message saying the driver being installed has not been validated for my computer.
Out of curiosity, if you zoom far away like 15 meters, will the character start appearing?
Forum Software Powered by Vanilla